GRASS VALLEY Encore, Руководство по настройке

Страница: 225 / 426

Encore — Configuration Manual 225
Panel Configuration Screen Description
• The
ID
button available for assignment on Control Panels equipped
with alphanumeric displays. If the panel is configured without a
Dest/ID
button (fixed Destinations), the
ID
button can be assigned instead.
Pressing this button initiates the Control Panel ID sequence (IP address,
etc.). The advantage of this button type over the
Dest/ID
button is the
new
ID
button can be used in any mode (Source/ Salvo), helpful when
a panel is configured with fixed destinations.
• The
Keypad Anywhere
button can be used to create unique panel keypads.
These buttons can enter user defined keypad Prefixes and Suffixes. See
Keypad Button Alternative Configuration on page 264 for more informa-
tion.
• The
Level/Inverse
button swaps all the Level selections (On Levels go Off,
and Off Levels go On.
• Pressing a control panel’s
Park
button will switch every active Level of
the active Destination to its Park input (as defined in the RCE, Physical
Matrix screen Segment window). When all Levels are parked success-
fully the panel displays
Parked
as the current Destination status. If no
Park input is defined on one or more levels, those Levels are left con-
nected to its current Source. If any Level other than the Tally level fails
to park, the control panel displays
Parked*
as the Destination status.
• The
Preset Source
button type is available on Control Panels that support
preset operations. Pressing this button presets that Source on that
panel, for a subsequent Take. This button type is configured using the
Panel Server in the normal manner (button Assignment followed by a
button Selection and saving the configuration).
• The
Src Cat Mode
button permits scrolling through the available Source
Categories of a Set, while the
Src. Cat Select
button chooses Sources from
a specific Source Category. See Source Categories on page 251 for more
information.
• The
Store
button is used for Dynamic Page Set Creation, available on
Encore PMB and SMS EDP, MB8, and MB4 control panels. This feature
allows a user to create a new Destination Page Set using the control
panel’s buttons, and apply it to that panel with the
Store button.