GLI International F53, Руководство по эксплуатации

Страница: 8 / 95

Model F53 Flow Monitor/Totalizer (universal-mount 1/2 DIN) Rev. 1-201 8
CONDENSED OPERATING INSTRUCTIONS
F. SELECTING SENSOR TYPE/ENTERING SENSOR DATA -- (continued)
GLI Tee Mount Sensor Setup (select TEE SIZE and TEE MATERIAL)
A. With the “SET SENSOR” screen displayed, use
Ø Ø
key to select the “TEE SIZE” line and
press ENTER key to display a screen like . Use
Ø
Ø
and
×
×
keys to select
the tee size in which the sensor is mounted:
•
0.5 INCHES
•
1.25 INCHES
•
3.0 INCHES
•
0.75 INCHES
•
1.5 INCHES
•
4.0 INCHES
•
1.0 INCHES
•
2.0 INCHES
•
1 IN. MHF15L2*
•
2.5 INCHES
*Select only when using a GLI PVC 1-inch MHF15L2 tee for higher flow range (up to 65 GPM).
B. With the appropriate tee size displayed, press ENTER key to enter this selection.
C. After the “SET SENSOR” screen re-appears, use
Ø Ø
key
to select the “TEE MATERIAL” line
and press
ENTER key
to display a screen like . Use
Ø Ø
and
× ×
keys
to
select the tee material, and press
ENTER key
to enter this selection. (Selected tee size de-
termines available tee materials.)
This completes GLI tee mount sensor data entry/calibration. The analyzer is now ready to meas-
ure Sensor A flow/volume.
GLI Pipe Mount Sensor Setup (SET PIPE ID)
A. Determine actual inside pipe diameter. Actually measure it or refer to an appropriate table.
NOTE: Pipe IDs for commonly-used Schedule 40 and Schedule 80 pipes are listed in Ta-
bles A and B in PART THREE, Section 4.2 under the “SET SENSOR Data”
subheading.
B. With the “SET SENSOR” screen displayed, use
Ø Ø
key
to select the “SET PIPE ID” line and
press
ENTER key
to display a screen like .
C. Adjust the displayed value to exactly match the actual pipe ID (inside diameter). Starting with
the extreme right blinking digit, use
Ø
Ø
and
×
×
keys
to adjust its value. (The longer the key is
pressed, the faster the value changes.) Then press
Õ
Õ
key once to select the next digit, and
use the
Ø
Ø
and
×
×
keys to adjust its value. Repeat this procedure until desired value is dis-
played, and press ENTER key to enter it.
This completes GLI pipe mount sensor data entry/calibration. The analyzer is now ready to measure
Sensor A flow/volume.
G. COMPLETING ANALYZER CONFIGURATION
To further configure the analyzer to your application requirements, use the appropriate CONFIGURE
screens to make selections and “key in” values. Refer to PART THREE, Section 4 for complete con-
figuration details.