PART THREE - OPERATION
SECTION 6 - TEST/MAINTENANCE
Model F53 Flow Monitor/Totalizer (universal-mount 1/2 DIN)
Rev. 1-201
70
S
ECTION
6
6.1 STATUS Checking
(analyzer, sensors,
and relays)
The analyzer has TEST/MAINT menu screens to:
•
Check operating status of analyzer, sensors, and relays.
•
Manually reset each totalizer volume.
•
Hold analog outputs at their last measured values.
•
Manually reset all relay overfeed timers at once.
•
Provide analog output test signals to confirm operation
of connected devices.
•
Test relay operation (energize or de-energize).
•
Test pulse output operation.
•
Identify analyzer EPROM version.
•
Simulate a selected sensor signal to exercise its related
measurement loop.
•
Reset all configuration values -- except those that define
sensor calibration -- to factory-set defaults.
The system diagnostic capabilities of the analyzer enable
you to check the operating status of the analyzer, sensors,
and relays. The MEASURE screen will flash the “WARNING
CHECK STATUS” message when a system diagnostic “fail”
condition has been detected. To determine the condition
causing the warning, display the “STATUS” screens:
1.
Press
MENU key
to display
&21),*85(
7(670$,17
(;,7
, and use
Ø
Ø
key
to select the “TEST/MAINT” line.
2.
Press
ENTER key
to display
.
3.
With the “STATUS” line selected, press
ENTER key
to
display the “STATUS: ANALYZER OK” screen. This
TEST/MAINTENANCE
