PART THREE - OPERATION
SECTION 4 - ANALYZER CONFIGURATION
Rev. 1-201
Model F53 Flow Monitor/Totalizer (universal-mount 1/2 DIN)
43
ENTER NOTE (top line
of measurement screen)
SELECT SENSOR Type
2.
Press
ENTER key
to display a screen like
. Use
Ø
Ø
and
×
×
keys
to view both
choices (AUTO RESET or MANUAL RESET). With the
desired choice displayed, press
ENTER key
to enter
this selection.
The top line of the eight MEASURE screen readouts that
separately display sensor flow rate and volume are factory
set to respectively read “SENSOR A,” “SENSOR B,”
“SENSOR C,” and “SENSOR D.” These notations can be
changed, for example, to “SYSTEM 1” and so on to tailor
the analyzer MEASURE screen readouts to the application.
Each notation is limited to eight characters which can be a
combination of capital letters A through Z, numbers 0
through 9, and spaces.
1.
With the
screen displayed, use
Ø
Ø
key
to select the “ENTER NOTE” line.
2.
Press
ENTER key
to display
. Create
desired notation within the second line parenthesis:
A.
Starting with extreme left character position, use
×
×
and
Ø
Ø
keys
to select the desired first character.
B.
Press
Ö
Ö
key
once to select the next character, and
use
×
×
and
Ø
Ø
keys
to select its desired character.
C. Repeat procedure until desired notation is displayed.
3.
Press
ENTER key
to enter the displayed notation.
To configure/calibrate the analyzer so that measured values
will accurately represent actual values, you must select the
sensor type and then enter its specific sensor-related data.
The data you enter depends on the sensor being used.
