Gerber P2C™ 600
User's Manual
Operation
2-11
2.3.6. OPTICUT
The OPTICUT submenu enables you to generate an enhanced overcut in order
to facilitate weeding. This feature, however, leaves little scratches on your
graphic and may not be appropriate for some media.
Press the
or
jogging key to change the value.
The default value is OFF.
The active opticut setting is marked with an asterisk (
!
) on the LCD.
2.3.7 EMULATE
The EMULATE submenu is used to select the cutter’s active cutting/plotting
language.
After pressing the
key, press the
or
jogging key until the desired
language is displayed on the LCD. Press
to confirm the new setting.
The Gerber P2C 600 supports DM/PL, HP-GL and HP-GL/2.
The active emulation setting is marked with an asterisk (
!
) on the LCD.
NOTE
The active cutting/plotting language MUST match the language set
in the cutting software.
Always select a language that is supported by the host computer's
cutting software.
Set the active cutting/plotting language to Houston Instrument Digital
Microprocessor/Plotting Language (DM/PL) whenever possible. This will allow
the cutter to operate with DM/PL-based cutting/plotting software which,
having special command extensions for cutting, normally gives superior cutting
performance.
