Gerber P2C™ 600
User’s Manual
General Information
1-17
Make sure that the pinch rollers are positioned over drive sleeves before being
lowered. When the pinch rollers are DOWN, they must run on top of the sleeves
in order to ensure proper media traction. It is very important that the edges of
the media always rest on the sleeves so that the two pinch rollers can be
positioned 3 to 15 mm (0.1" to 0.6") in from the edges of the media.
1.7.2. FEEDING AND POSITIONING MEDIA
The following load procedure has been found to be very reliable. Adhere to
these step-by-step instructions when loading media.
!
!
!
!
To load media, proceed as follows:
1. Raise the pinch rollers by lowering the pinch roller lever located at the
back of the cutter.
FIGURE 1-5:
MEDIA POSITIONING
2. When working with roll media, proceed by inserting a media flange at
each end of the roll and then tighten the thumbscrews until the media roll
is firmly gripped between the flanges. Make sure the flanges are firmly
pressed against the roll. Place the flanges on the media support rollers at
the rear of the machine.
3. Position the flanges on the support rollers at the rear of the cutter.
