Gerber P2C™ 600
User’s Manual
General Information
1-20
6.
The cutter is now ready for the actual load procedure that starts once the
pinch rollers are closed. Raise the pinch roller lever to lower the rollers onto
the media and drive sleeves. The tool carriage will automatically begin
moving left and right to sense the usable media width.
NOTE
It is not necessary to pull the media manually from the roll. The cutter
will unroll the media automatically during the load sequence.
7. The positioning and routing of sheet media is identical to that of roll media.
With sheet media, the front and back alignment strips must be used to be
sure that the media lays straight.
8.
SAFE OPERATION
Do not place any objects in front of, or behind, the cutter that could
interfere with cutter operation. Make sure the media is free to move
forward and back. Keep hands, hair, clothing, and jewelry away from
moving parts.
If the cutter is not already turned on, flip the power switch located next to
the power entry module at the rear of the machine. The following message
will appear on the LCD screen:
PLEASE WAIT
If there is media loaded in the cutter and the pinch rollers are down, the
cutter will automatically start executing a minimal loading procedure
consisting of:
- A media width measurement
- A 45° test
- Media is unwound equal to the width measured
between the pinch rollers
When the next display appears, the cutter is ready to receive a file:
700mm/s 80 g
For a manual loading procedure, refer to paragraph 2.2.10
