Gerber P2C™ 600
User’s Manual
General Information
1-18
Slide the two media guides under the media roll so that each flange rests
in the groove in the guide. In this position, the media roll and guides can
be shifted left and right.
Feed the media from the rear of the cutter.
Position the left edge of the media on the leftmost drive sleeve and then
check to see whether the right edge of the media is positioned over the
wide drive sleeve. If it is, the left pinch roller can be positioned in the detent
above the leftmost sleeve. Then, the right pinch roller can be positioned
somewhere over the wide drive sleeve according to the media width. The
right pinch roller can be located anywhere between the two outer detent
positions above the long drive sleeve. This flexibility allows the Gerber P2C
600 cutters to accommodate various media widths.
The alignment strips on the front and back of the cutter can be used for
quick reference if the vinyl has a standard width. Marks are provided to aid
in media alignment: 50cm, 15"/38CM, 16"/41CM, and 24"/61CM.
If this does not work because the media is too narrow to reach the long
drive sleeve, try positioning the left edge of the media over the second
narrow drive sleeve. Then, reposition the right edge of the media
somewhere on the wide drive sleeve. If the media is still too narrow,
position the left edge of the media over the drive sleeve that is closest to
the wide sleeve, and reposition the right edge of the media somewhere on
the wide drive sleeve.
FIGURE 1-6:
FEEDING ROLL MEDIA USING MEDIA FLANGES
