Gerber P2C™ 600
User’s Manual
General Information
1-11
1.
USB interface:
- This interface is based on the standards specified in
Universal Serial Bus Specifications Revision 1.1. USB connectivity can be
used to establish high-speed bi-directional communication serially
between the host computer and the cutter. Use either the USB cable or
the 9-pin serial cable, but not both simultaneously.
2.
RS-232-C Port: -
This DB-9P connector uses a 9-pin serial cable to establish
bi-directional communication between the cutter and a host computer.
Use either the 9-pin serial cable or the USB cable, but not both
simultaneously.
3.
Power
ON/OFF switch:
- This rocker switch sets the cutter’s power to ON or
OFF. To switch the power ON, press the “I” side of the rocker switch. To
switch the power OFF, press the “O” side of the rocker switch.
4.
Power Entry Module: -
The fuse box and the AC power cord receptacle
are located in the power entry module.
The power-up procedure is explained in detail in Section 1.6.
5.
Fuse box: -
For information about changing the fuse, see Section 4.2.
6.
Roll
Media Guides:
- The two guides keep the media roll in place as the
cutter pulls media from the roll.
7.
Media Flanges:
- The media flanges ensure proper routing of the media as
it is pulled from the roll.
8.
Media Support Roller:
- The rotating rollers support the media roll.
9.
Alignment Strip:
- The rear alignment strip facilitates proper media loading
and should be used in conjunction with the front alignment strip.
