Gerber P2C™ 600
User’s Manual
General Information
1-21
When receiving a cut file, the cutter will automatically pull from the roll a
length of media equal to the width of the pinch rollers. Media is then
pulled successively from the roll in increments equal to the width of the
rollers.
1.8. INSTALLATION OF A KNIFE, PEN OR POUNCING TOOL
1.8.1. KNIFE INSTALLATION
!
SAFETY WARNING
Your cutter uses razor-sharp knives. The knife blades may cause
serious personal injuries if handled without proper care. Exercise
caution when operating the cutter and when installing, removing or
handling the knife!
!
!
!
!
To set up your cutter for knife operation, proceed as follows.
1.
As shown in Figure 1-9, insert the knife blade into the knife holder using a
pair of tweezers.
adjustment
knob
FIGURE 1-9
BLADE INSERTION
2.
Set the knife blade length to zero by aligning the blade tip with the tip of
the holder. An easy way of performing this is by holding the knife holder
against your fingertip and gradually increasing the blade length by
turning the adjustment knob until you feel the knife tip touching your
fingertip.
