GBC StreamWire, Руководство по обслуживанию

Страница: 93 / 455

Book Quality 07/23/2020 GBC StreamWire
3-6
3.3.3 Common Spool Damage
The wire on the spool may become damaged when not properly handled.
This may cause jams in eWire. In this section there are examples of
common issues you may see on a spool. Any damaged wire must be
removed using the wire cutters provide. They are located on the inside
of the element feeder door. When cutting the wire, cut the wire in the
center of the larger loop as shown below. Excess paper can then be
removed, leaving 12 inches (30 cm) past the new end of the wire. The
spool can then be reinstalled.
Cutting Wire
When part of the spool of wire is damaged, it must be removed using the
wire cutters provide. They are located on the inside of the element feeder
door. When cutting the wire, cut the wire in the center of the larger loop
as shown below. Excess paper can then be removed, leaving 12 inches
(30 cm) past the new end of the wire.
Stretched Wire
Wire can become stretched when installing or removing a spool from the
machine, it may also become stretched due to wire jams. If any length of
wire is stretched like shown below, use the wire cutters provided to cut
that section off. Wire is considered stretched if the loops are no longer
parallel to each other. The wire outlined in red is an example of stretched
wire.
Crushed Wire
Wire can become crushed when the spool is miss handled. Below is an
example of a crushed length of wire. Crushed wire must be cut off and
discarded.