GBC StreamWire, Руководство по обслуживанию

Страница: 60 / 455

GBC StreamWire 07/23/2020 RTPS
2-45
5. Check if the set screws on all the six pulleys associated with the
Holder linear drive are tight
The set screws are tight
Yes - Go to Step 6;
No - Tighten the loose set screw(s) and resume operation
6. Manually move the Holder linear mechanism and watch if the sheet
metal feature blocks/unblocks S38 Holder Stack position sensor.
The sensor is blocked/unblocked properly
Yes - Go to Step 7;
No - Escalate to second level
7. Do GP 6.5 to check M15 Holder linear drive motor
This clears the fault
Yes - Return to normal operation;
No - Go to step 8
8. Inspect the springs for the Holder gates (PL 5.21).
Holder gates springs are present and not damaged
Yes - Go to Step 9;
No - Replace the missing/damaged spring
9. Do 6.3.5 FIRMWARE UPGRADE Procedure to Re-flash the firmware
for eWire.
This clears the fault
Yes - Return to normal operation;
No - Go to Step 10
10. Do REP 11.2 “B” Main Control Board Replacement
.
This clears the fault
Yes - Resume operation;
No
- Escalate to second level