GBC StreamWire, Руководство по обслуживанию, Страница: 278 / 455

GBC StreamWire 7/23/2020 Repairs/Adjustments
4-181
ADJ 1.3 Holder Mating To Element Feeder
For proper operation, the element holder module should mate to the
element feeder without any hesitation or mechanical resistance. The two
locating pins on the element holder should smoothly engage the element
feeder.
Adjustment Procedure
1) Perform function test Holder to Xfer GP 6.3.4 to mate the holder to
the element feeder.
Service Settings Menu

Function Tests

Holder to Xfer
2) If the element holder locating pins do not slide smoothly into the
element feeder locating holes (See Fig 1), then the alignment needs
to be corrected. This can also be checked by manually moving the
holder to make the pins move slowly in and out of the feeder location
holes
a) Check the
horizontal
alignment as shown in Fig 2.A and Fig 2.B.
i) If an adjustment is needed follow ADJ 1.15
ii) After adjustment, attempt to engage the holder into the
element feeder by hand again while checking the alignment.