Garmin GMX 200, Руководство по установке

Страница: 9 / 106

GMX 200 Installation Manual Page 1-1
190-00607-04 Revision D
1 General Description
1.1 Scope
The information in this manual is STC approved. Only the equipment interfaces covered in this manual
are within the scope of this STC. Other equipment may be suitable for use with the GMX 200, but use of
such equipment is beyond the scope of this STC – additional FAA approval may be required if equipment
not covered in this manual is used to interface to the GMX 200.
This document describes the GMX 200 operating with software Version 2.00 and later. All references to
the GMX 200 apply to both the GMX 200 and GMX 200 I/O models, and references applicable to the
GMX 200 I/O model only are identified as such.
Refer to Section 7, Limitations, for additional information.
It is possible for installers to seek evaluation and approval of an alternate installation by means of the
field approval process. This manual and all the data contained within may be used by the installer in
pursuit of a field approval.
1.2 Introduction
This manual describes the installation of the GMX 200 Multi-Function Display. It is intended for use by
persons certified by the Federal Aviation Administration (FAA) to install avionics. It includes installation
and checkout procedures for the GMX 200 to standards described in 14CFR Part 43. This installation
manual applies to GMX 200 models listed in Table 2-1.
Figure 1-1. GMX 200 Unit View