G&D DVI-Vision-IP-Fiber, Инструкция по установке и эксплуатации

Страница: 137 / 240

Installation
12 · G&D DVI-Vision-IP-Fiber
Installing console modules
The remote console is connected to the DVI-Vision-IP-Fiber-CON console module. The
computer connected to the computer module can be operated from this console.
Establishing a connection to a local management network
Network Management: Insert a category 5 twisted pair cable (or better), which is availa-
ble as accessory. Connect the other end of the cable to the local network.
Connecting keyboard and mouse of consoles and other devices
Keyb./Mouse: Connect the mouse and/or the keyboard of the console to this interface.
Generic:
In the default settings, you can use this interface to connect another USB
input device, a supported display or tablet, or a USB mass storage device.
Activate the
generic USB
mode (see
(De)Activating an USB keyboard mode the »Generic
USB« mode
on page 87) if you want to connect another USB input device or USB
mass storage device. In this mode, any data of the USB device is
not altered
when trans-
mitted to the computer module.
NOTE:
If desired, connect this network interface to a local network. This enables
you to access the Config Panel web application from this network and to send sys-
log messages to this network.
NOTE: Both the keyboard and the mouse of the console can either be PS/2 or USB
devices.
IMPORTANT: If the generic USB mode is active, the OSD cannot be operated by a
keyboard connected to the Generic socket.