Gamewell IDENTIFLEX 632, Руководство по установке и эксплуатации

Страница: 135 / 186

IF 632 Installation and Operation Manual Release: 3 01/31/01
135
Dictionary File
The dictionary file format consists of the five dictionaries, each separated by two fore
slashes (//) as delimiters. The first line of the dictionary file would contain two fore slashes
indicating that it is the beginning of the file and the next line received will be word #0 of
dictionary #1. This line should be left blank since each device defaults to
word #0 of each dictionary. The following lines would contain the desired text entries, in
numerical order, for dictionary #1. When all of the entries for dictionary #1 have been
entered two fore slashes should be inserted on the next line to signify the end of dictionary
#1 and the start of dictionary #2. Again the next line, word #0 dictionary #2, should be left
blank for default purposes. This format is followed throughout the five dictionaries. The
end of dictionary five is also signified by two fore slashes.
Some important points to keep in mind when writing the file are as follows. Dictionary #1
through dictionary #4 may contain up to 128 entries (0-127). Dictionary #5 may contain up
to 1024 entries (0-1023). If all of the entries in any one dictionary are not used, the file
does not need to contain blank lines before terminating the dictionary with two fore slashes.
Each dictionary entry may contain up to 40 characters. However, entries from dictionaries
#1 and #2 are displayed on the third line of the alphanumeric display, and, entries from
dictionaries #3, #4, and #5 are displayed on the fourth line of the alphanumeric display.
The total characters of dictionary entries used in conjunction with each other should not
exceed 40 characters.
The file below illustrates a simple dictionary file.
//
Fire Alarm
Supervisory Alarm
//
Smoke Detector
Heat Detector
//
First Floor
Second Floor
Third Floor
//
Stairwell
Computer Room
Mechanical Room
//
Room 111
Room 112
Below Raised Floor
//
>> NOTE: For Procomm only, the ASCII transfer setup must
have the following parameters. Use the following table):
Technical Manuals Online! - http://www.tech-man.com
firealarmresources.com