Gamewell IDENTIFLEX 632, Руководство по установке и эксплуатации

Страница: 103 / 186

IF 632 Installation and Operation Manual Release: 3 01/31/01
103
Field Descriptions for Signal Circuits and Analog Addressable
“Ckt:xxx” Indicates the signal circuits memory address
“Add:xxx Address of analog relay module
“D_Type:Sig” Shows the type of output circuit
“ALR:x” Indicates to what alarm level the circuit will be activated in
the event that “and” zones are programmed.
>>NOTE: The use of Cross and Counting Zones must comply with the
applicable requirements of NFPA 72, 3-8.2.5:
Systems that require the operation of two automatic detection
devices to initialize the alarm response shall be permitted,
provided:
(a) They are not prohibited by the authority having jurisdiction.
(b) There are at least two automatic detection devices in each protected space.
(c) Automatic detection device area spacing is no more than
one-half that determined by the application of NFPA 72
Chapter 5.
“Sig:xxx” Indicates the type of signaling to be output by the circuit (i.e.
steady, marchtime, etc). Refer to Output Signal Circuit Type for a complete
description .
“Res:xxx” Indicates when the signal circuit has been programmed to
return to normal. Refer to Signal Circuit Restore
for a complete list of options.
“DRL:x” Indicates if a signal circuit will activate when the drill switch is depressed.
“Sil:x” Auto Silence – Programmable, 2 – 15 min..
“O_Grp:xxx” Identifies the output group.
“Seq:”
Sequentially Restores.
>> NOTE: If an analog addressable line (or single device) is
not programmed when selected, the result is no action.
4. Program the signal circuit by using the left/right arrow keys to move between fields and the
up/down keys to assign the desired characteristics.
5. To exit output circuit programming press the “
Enter
” key.
Technical Manuals Online! - http://www.tech-man.com
firealarmresources.com