Fukuda Denshi DS-8200, Руководство по обслуживанию

Страница: 169 / 219

Rotary Switch Setup
The Rotary switch is located inside the maintenance cover of the LC-8210.
SW No. Default Description
0 ON Normal operation mode
1 Not used.
2
Demo mode
(Displays the Demo Start Menu on the Test Menu.)
3
Do not use the key coordinate data and use the default
value.
4
～
6 Not used.
7
Set up when adjusting analog for factory shipment,
adjusting analog after replacing the board at service
division, or using the function for development evaluation.
8 ～ B
Not used.
C
Clear key for integrated time
D
Not used.
E
For EEPROM writing
F Initialize internal setup to factory default setup.
0: Normally, set the rotary switch to “0”.
2: To start the demo, press the demo start key on the test menu.
To enter the test menu, the password, “11111111” is required.
7: This mode will be set when adjusting analog for factory shipment, adjusting analog after
replacing the board at service division, or using the function for development evaluation.
If this mode is entered without adjustment information/facility, and the factory setting is
changed, the equipment may become unusable.
C: When the power is turned ON with this mode, clear key for integrated time will be displayed
on the test menu.
E: Enables to write equipment information to EEPROM.
F: When the power is turned ON with this mode, the user settings will be initialized.
10-3