Fuji Electric Time Delta-C FSV-2, Инструкция по эксплуатации

Страница: 97 / 149

-90-
4.15.4. Checking the total pulse output action
Description
 Checks the action of total pulse output.
The output action can be checked upon designating the number of pulses to be outputted per second.
Settable range: 1 to 100 pulses/s (when pulse width is 5ms, 10ms, 50ms,100ms or 200ms)
Note 1) The output pulse width is as selected currently. (See 4.12.2.1.)
Set the frequency taking the pulse width into account referring to the following expression.
The number of setting pulses  1000/(Pulse width[ms] × 2)
Example: If the pulse width is set to 50ms, select 10 pulses/s or less.
Note 2) When pulse width is 500ms and 1000ms, output action is performed at the rate of 1pulse/4seconds regardless of setting.
 This operation sets DO1, DO2, DO3, and DO4 the same contact action.
 Before operation, check whether DO output testing is permitted.
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.5.1.)
Operation
(example) Perform pulse output of 5 pulses/s.
Key operation Description Display
▼
Press the key for 4 times to display “MAINTENANCE MODE”.
MAINTENANCE MODE
ENT
▼
Press the
ENT
key once to display “RAS INFORMATION”.
RAS INFORMATION
▼
Press the key for 4 times to display “TOTAL PULSE”.
TOTAL PULSE
1 PULSE/s
ENT
▼
Press the
ENT
key once to blink the cursor.
Note) Start simulated pulse output.
TOTAL PULSE
0 01 PULSE/s
▼
Press the key twice to move the cursor.
TOTAL PULSE
00 1 PULSE/s
▼
Press the key for 4 times to set “5”.
TOTAL PULSE
00 5 PULSE/s
Press the
ENT
key once to register.
TOTAL PULSE

COMPLETE

↓
ENT
▼
▼
▼
▼
――― 5 PULSE/s has been registered. ―――
5 PULSE/s simulated pulse is output.
TOTAL PULSE
00 5 PULSE/s
ESC
▼
After checking the output, press the
ESC
key once to stop simulated
pulse output.
TOTAL PULSE
005 PULSE/s
ESC
Press the
ESC
key once and then press the key once to enter the
measurement mode.
0.000 %
0.000 m3
CAUTION