MT6M15962a
© Fuji Electric Co., Ltd. All rights reserved.
1-14
Fig.1-9 Package outline drawing (P631)
11.7
4.8 P631 package (6in1/7in1 with upper and lower arm alarm signal output)
• The line-up is 200A to 450A for 650V and 100A to 300A for 1200V.
• Terminal pitch of the control terminals is standard 2.54 mm and can be connected with general-
purpose connectors and soldering.
• The main power input (P1, P2, N1, N2), brake input (B), and output terminals (U, V, W) are located
close to each other, making main wiring easy. The P1 and P2, N1 and N2 terminals are internally
connected.
• The main terminals are M5 screws, allowing high current connections to be made securely.
• Screw size for the heat sink is M5 common with the main terminals.
• All electrical connections are done with screws and connectors, thus no soldering is required and
easy to remove.
• Compatible with R-IPM series P612. (Excluding the control terminal part)
• The package outline drawing is shown in Figure 1-9.
Note:
1. The dimensions shown in
□
represent the theoretical dimension.
2. The terminal pitch is the value at the root of the terminal.
3. Dimensions in ( ) are given only for reference.
4. Main terminal plating: Ni
Control terminal plating: Ni plating on the ground, Au plating on
the surface. (for connector and soldering use)
5. The guide pins located on both sides of a control terminal are
made of brass.
(They are insulated internally and are not connected to any object.)
[Unit of dimensions
：
mm]
