Fuji Electric Faldic-a RYS-R Series, Руководство пользователя

Страница: 141 / 291

5-29
MHT260a (Engl.)
■
Parameter setting
To allocate the [TLMT] signal to the control input terminal, set (30) to the system para.. If the [TLMT] (30) signal is not allocated to the control
input terminal, the setting of basic para. 59 is always valid.
To allocate the torque limit detection signal to the control output terminal, set (26) to the system para..
5.6.4 External fault input
External signal forcibly stops the motor.
External fault input (Control input signal)
■
Function
While this signal is turned off, the motor is stopped forcibly.
While external fault input is applied (signal off), the operation is the same as forced stop [EMG] (10).
While external fault input is applied (signal off), forced stop detection (41) signal is turned on.
■
Parameter setting
To allocate the external fault input signal to the control input terminal, set (34) to the system para.. If this signal is not allocated to the control
input terminal, this signal is deemed "always on".
■
Related item
See 5.6.1 for the forced stop (10).
5.6.5 Overload early warning
Motor’s load factor can be checked.
Overload early warning (Control output signal)
■
Function
This signal is turned on, when the motor load factor has reached the overload early warning level set at the basic para. 58.. This signal cannot
be reset by the control input signal (external signal input).
Early warning signal can be outputted before the amplifier trips due to motor overload alarm.
■
Parameter setting
To allocate the overload early warning signal to the control output terminal, set (27) to the system para..