Fronius RCU 5000i, Инструкция по эксплуатации и запасные части

Страница: 125 / 248

125
EN
End of welding
Guideline values Current guideline value
The current guideline value [A] is normally determined by trial and error or by performing
a test weld.
Guideline value for material
The guideline value for the material strength [mm] is normally determined by trial and error
or by performing a test weld
Voltage guideline value
The voltage guideline value [V] is normally determined by trial and error or by performing
a test weld. On the TS 4000/5000 and TPS 2700/4000/5000 power sources, the voltage
guideline value corresponds to the voltage on the contact tube.
Wirefeed speed
The guideline value for the wire feed speed [m/min] is normally determined by trial and er-
ror or by performing a test weld.
Accepting volt-
age and current
guideline values Voltage and current guideline values are accepted by the remote control unit directly from
the test weld:
Voltage and current guideline values during test weld,
continuous black selection bar
Set welding voltage and welding cur-
rent at the power source
Perform test weld
– During the welding process, the
present values for welding voltage
and welding current appear as ac-
tual values on the remote control
unit. The values cannot be altered
during the welding process; the
selection bar appears completely
black.
At the end of welding, the last active
hold values for welding voltage and
welding current are accepted as volta-
ge and current guideline values. Volta-
ge and current guideline values can be
kept or reset.
t_burnback
Duration of the currentless wire withdraw [ms] after the welding current has been
switched off (v
D
= -6 m/min)
1
2
3