Fronius RCU 5000i, Инструкция по эксплуатации и запасные части

Страница: 231 / 248

231
EN
Gen. Parameter control
for setting whether parameters will be entered internally or externally
Unit
-
Range Internal/External
Ground current
characteristic parameters for setting the base current value, which is
maintained independently of the voltage
Unit
[A]
Range min. - max.
Group number
various jobs are grouped together
Unit
-
Range 0 - 99
Guideline value for material
The guideline value for material strength is normally established by trial and error or by
means of a test weld; it has no influence on the welding parameters
Unit
[mm]
Range 0 - max.
Hot-current time Hti
for setting the length of time the HotStart current is active
(Hti)
Unit [s]
Range 0 - 2
HotStart
A
rc L ength S tart - for setting an increased arc length for welding start-
up, for MIG/MAG synergic welding, standard welding process.
ALS
Unit [%]
Range 0 - 100
HotStart current HCU
HotStart current - for setting the HotStart current for MMA welding
(e.g. for improved ignition properties)
(HCU)
Unit [%]
Range 0 - 100
HotStart pulse cycles
for setting the HotStart pulse cycles in the case of CMT characteristic C0875
Unit
-
Range -5.0 - +5.0
HotStart time (a)
A
rc L ength t ime - for preliminary setting of the time, during which for
MIG/MAG Synergic welding, standard welding process, the increased
arc length will be continually reduced to the currently set value of the
arc length.
ALt
Unit [s]
Range Off/0.05 -5.00
HotStart time (b)
for setting the value for the HotStart time in the case of CMT charac-
teristics C0873, C0876 and C0877
ALt
Unit -
Range -5.0 - +5.0