Fronius RCU 5000i, Инструкция по эксплуатации и запасные части

Страница: 229 / 248

229
EN
EN_tau_boostup
for setting the non-linear current rise rate at the start of the boost phase for CMT charac-
teristics
Unit
[ms]
Range 0.08 - 5.00
EN_vd_sc_wait
for setting the wire feed speed following the boost phase until the dip-
ping of the wire electrode into the weld pool
Unit
[m/min] [ipm]
Range 0.00 - 80.00 0 - 3,150
Every n seconds
for setting the period of time after which documentation is to occur
Unit
[s]
Range Off/0.1 - 9.9
Every n-th seam
for setting the number of weld seams after which documentation is to occur
Unit
-
Range 1 - 100
Fact-f-control (p)
effect of control deviations on the frequency
Unit
[%]
Range 0 - 50
Fact-f correction
alteration facility for constant current
Unit
[%]
Range 0 - 50
Fact-I_b control (pi)
Effect of deviations on the base current
Unit
[%]
Range 0 - 50
Fact-I_b correction
effect of the arc length correction on the base current
Unit
[%]
Range 0 - 50
Fact-I_p1 control (pi)
effect of deviations on the pulse current
Unit
[%]
Range 0 - 50
Fact-I_p1 correction
effect of arc length correction on the pulse current
Unit
[%]
Range 0 - 50
Feeder creep
for setting whether parameters will be entered internally or externally
(Fdc)
Unit [m/min]
Range SFI/Auto/Off/0.5 - maximum