Fronius RCU 5000i, Инструкция по эксплуатации и запасные части

Страница: 241 / 248

241
EN
Voltage guideline value
The voltage guideline value is normally determined by trial and error or by performing a
test weld. On power sources TS 4000/5000 and TPS 2700/4000/5000, the voltage guide-
line value corresponds to the voltage on the contact tip; it has no influence on the welding
parameters
Unit
[V]
Range 0 - max.
Voltage set value
a) reference voltage for Q-Master values
b) voltage set value for the standard arc when optimising characteristics
c) voltage set value for operating the power source with constant welding voltage in CC/
CV mode
Unit
[V]
Range min. - max.
Welding current
for MMA welding
Unit
[A]
Range 0 - max.
Welding voltage
For MIG/MAG standard manual welding
Unit
[V]
Range 0 - max.
Wire feed speed deviation
for setting the wire feed speed deviation: in SynchroPulse, the set
wire feed speed is alternately increased/decreased by the wire feed
speed deviation. The parameters concerned adapt themselves to this
wire feed speed acceleration/delay accordingly.
(dFd)
Unit [m/min]
Range min. - max.
Wire feed speed
for setting the wire feed speed for MIG/MAG synergic welding, MIG/MAG standard man-
ual welding and in CC/CV mode
Unit
[m/min]
Range min. - max.
Wire-end cut-out
for pre-setting whether the wire end will stop immediately at the end
of a seam, or not at all
(FCO)
Unit -
Range none/end of seam/immediately
Wire-stick control
for presetting whether the wire-stick control is to be switched on or off
(wire stick control checks whether the welding wire sticks after weld-
ing)
(Stc)
Unit -
Range Off/On
Year
for presetting the year in the date display
Unit
-
Range 1996 - 2095