POSITIONING THE CONTROL PANEL
When choosing a suitable location for the Control
Panel, the following points should be considered.
1. The Control Panel should be located in a position
out of sight of potential intruders and in a safe
location, but easily accessible for system
operation.
2. The Control Panel should be mounted on a sound
flat surface to ensure that the rear tamper switch
on the Control Panel is closed when the Panel is
mounted. The Control Panel should be mounted at
a convenient height of between 1.5 and 2m and in
a position where it will be seen each day.
Note: If small children are in the household, a
further consideration should be given to keeping
the units out of their reach.
3. It is recommended that the Control Panel should
be positioned such that the Exit/Entry tone
(emitted by the Control Panel) can be heard from
outside the property.
4. The Control Panel should be mounted within a
protected area so that any intruder cannot reach
the Control Panel without opening a protected door
or passing through an area protected by a PIR
movement detector when the system is armed.
5. The Control Panel must be located within reach of
a mains socket.
6. If the telephone voice dialler is to be used then the
Control Panel will need connecting to a convenient
telephone point.
7. Do not locate the Control Unit closer than 1m to any
large metallic object, (e.g. mirrors, radiators, etc) as
this may affect the radio range of the Control Panel.
INSTALLING THE CONTROL PANEL
1. Undo the two captive fixing screws on top of the
panel and open the cover. The cover is hinged along
the bottom edge.
2. Unclip and remove the two back-up batteries on
either side of the panel.
3. Hold the Control Panel in position on the wall and
mark the positions of the four fixing holes. Remove
the Panel and drill four 5mm holes and fit the 25mm
Wall Plugs.
Note: The wall plugs supplied with the product are
not suitable for plasterboard walls, if mounting the
Control Panel onto plasterboard use proprietary
wall plugs.
CONTROL PANEL
ZONE 1
1
4
2
3
5
6
7
8
0
ENTER
ESC
#
ZONE 2
ZONE 3
ZONE 4
TAMPER
FIRE
ZONE 6
ZONE 5
POWER
PART ARM
ARM
LOW BATT.
9
!
Zone LEDs
Status LEDs
Keypad
Outside View of Control Panel
7
