INSTANT/DELAY ZONES
Default setting: zone 1: Delay, zones 2-6: Instant
Press ,
The zone LEDs corresponding to the zones currently
set to Delay will be illuminated. LEDs for zones set to
Instant will be OFF.
LED ON
Delay Zone
LED OFF
Instant Zone
To change the settings of a zone press the button
corresponding to the zone number. The zones will
switch to the opposite mode each time the button is
pressed.
Press to save the new setting and return to
programming mode.
Press to return to programming mode without
saving.
ENTRY/EXIT DELAY
Default setting: 30 seconds
Press ,
The zone LED corresponding to the current setting will
illuminate.
0
no delay, (i.e. Instant)
1
10 seconds
2
20 seconds
3
30 seconds
4
40 seconds
5
50 seconds
Press the key corresponding to the required delay
setting, the corresponding zone LED will illuminate as
the setting is changed.
Press to save the new setting and return to
programming mode.
Press to return to programming mode without
saving.
ALARM DURATION
Default setting: 3 minutes
Press ,
The zone LED corresponding to the current setting will
illuminate.
0
no alarm
1
1 minute
2
2 minutes
3
3 minutes
4
5 minutes
5
10 minutes
Press the key corresponding to the required alarm
period, the corresponding zone LED will illuminate as
the setting is changed.
Note: When set to ‘No alarm’ the Siren will sound for
approximately 10s if an alarm condition is initiated.
Press to save the new setting and return to
programming mode.
Press to return to programming mode without
saving.
Note: Following initiation of a Full Alarm condition the
External Siren will continue to sound until either the
system is Disarmed; or the Control Panel Alarm
Duration Time expires; or if activated until the 3 minute
alarm time limit of the external Siren expires;
whichever occurs first.
PART-ARM
Default setting: zone 1: Disabled, zones 2-6: Active
Press ,
The zone LEDs corresponding to the zones currently
active during Part-Arm mode will be illuminated. LEDs
for zones disabled during PART-ARM will be OFF.
LED ON
Zone enabled in Part-Arm
LED OFF
Zone disabled in Part-Arm
To change the setting of a zone press the button
corresponding to the zone number. The zone will
toggle between the two modes each time the button is
pressed.
Press to save the new setting and return to
programming mode.
Press to return to programming mode without
saving.
21
4
5
6
ESC
ENTER
ESC
ENTER
ESC
ENTER
ESC
ENTER
3
