RECORD ALARM MESSAGE
Default setting: not programmed
Press ,
The zone 1 LED will illuminate.
Press to start the voice recorder.
Zone LED 1 will flash while recording. The maximum
allowable length of the alarm message is 32s. After
this period the Panel will beep twice to indicate
that the recording has stopped and returned to
programming mode.
Alternatively press to stop the recorder before
the max 32s and cancel any unused message time.
REPLAY ALARM MESSAGE
The recorded alarm message may be replayed and
listened to using the telephone handset of a phone
connected to another extension socket on the same
phone line.
Press ,
The zone 1 LED will illuminate.
Pick up the telephone handset and press to
stop the dialing tone.
Press to start replying the recorded alarm
message.
Zone LED 1 will flash while the alarm message is being
replayed. At the end of the message the Panel will
beep twice and returned to programming mode.
Alternatively press to stop replaying the
message before the end and return to programming
mode.
CALL ROUTING
This controls which telephone numbers are enabled in
the dialling sequence and are dialled when the voice
dialler is activated.
Default setting: All numbers inactive
Press ,
Zone LEDs 1-4 will be illuminated to indicate the active
status of telephone numbers 1-4 in the routing sequence.
LEDs for telephone numbers disabled will be OFF.
LED ON
Telephone number enabled
LED OFF
Telephone number disabled
To change the active status of a phone number press the
button corresponding to the phone number. The LED will
toggle between states each time the button is pressed.
Press to save the new number and return to
programming mode.
Press to return to programming mode without
saving.
CALL ATTEMPTS
This sets the maximum number of times that the
dialler will attempt to contact each enabled phone
number in the call routing sequence.
Default setting: 3
Press ,
The zone LED corresponding to the current setting will
illuminate.
Zone 1 LED
1 attempt
Zone 2 LED
2 attempts
Zone 3 LED
3 attempts
Zone 4 LED
4 attempts
Zone 5 LED
5 attempts
Press the key corresponding to the required number of
dialling attempts, the corresponding zone LED will
illuminate as the setting is changed.
Press to save the new setting and return to
programming mode.
Press to return to programming mode without
saving.
DIAL METHOD
This enables the telephone dialler to be configured for
the type of exchange it is connected to.
Note: Most installations withn the UK are now operating
on a Tone/DTMF based exchange.
Default setting: Tone/DTMF
Press ,
The zone LED corresponding to the current setting will
illuminate.
1
Tone/DTMF
2
Pulse
24
ESC
ENTER
ESC
ENTER
ESC
ENTER
ESC
ENTER
2
2
2
3
2
5
2
6
2
4
