11. The Solar Siren will acknowledge Disarm signals
from the Remote Control and Service Mode
signals from the Control Panel by beeping. It is
possible to disable these acknowledgement beeps
if required by removing the jumper link P2 on the
circuit board.
P2 fitted
beep enabled
P2 removed
beep disabled
12. If for any reason you need to disable the Siren,
remove jumper link P3 on the circuit board. This
will prevent the Siren from sounding during an
alarm condition. However, the Siren will still beep
to acknowledge signals from the Remote Control,
(provided the beep feature is not disabled).
P3 fitted
Siren enabled
P3 removed
Siren disabled
13. Refit the DIP switch cover and replace the three
cover fixing screws. Do not over tighten the screw
as this could damage the thread.
POWER-UP OF THE SOLAR SIREN
1. Connect the 9V PP3 initial power battery to the
battery clip.
Connect the rechargeable battery to the charging
leads. Connect the Red lead to the Red (+ve)
terminal and the Black lead the Black (-ve)
terminals.
IMPORTANT: Once the batteries have been
connected, the Siren will be operational and it is
important that the solar panel receives sufficient
light to maintain the battery charge. The Siren
should not be operated repeatedly during
installation and testing, as this will rapidly drain the
battery. It is recommended that the Siren be left for
at least a day in order to charge the battery before
the system is Armed.
2. Press the anti-tamper switch, the LEDs will flash
together to indicate that the unit is operational.
3. Hinge the front cover locating tabs over the top
edge of the back plate and carefully push the base
of the siren cover into place. Secure the Siren
cover in place by refitting the fixing screw in the
bottom edge of the cover. Do not over tighten the
screw as this could damage the thread.
IMPORTANT: Ensure that the rear tamper switch
is closed when you fit the siren cover to the back-
plate (i.e. listen for the switch to click). If the switch
does not close this will prevent the Solar Siren
from operating correctly. If necessary, remove the
siren cover again and adjust the screw on the
back-plate tamper plunger to ensure the switch
closes when the Siren is secured in position.
4. If fitted remove the protective film covering the
Solar Panel.
TESTING THE SOLAR SIREN
Ensure that the system is in Test mode, (see page 18).
1. Press on the Control Panel.
The Control Panel alarm and Solar Siren will
operate for a period of approximately 5 seconds
with the Solar Siren switching ON and OFF a few
seconds after the Control Panel.
Note: To stop the siren test before the 5s period
has elapsed press on the Control Panel.
17
3
ESC
