3. Switch OFF the mains supply to the plug-in PSU
Adapter and remove the plug from the DC power
socket in the Control Panel.
4. Remove either back-up battery and disconnect the
battery leads.
5. Set jumper link P1 to the ON position.
6. Reconnect the battery leads and replace the back-
up battery in position.
7. The Control Panel will now reconfigure itself with all
factory default settings. This takes approximately
10 seconds.
8. Reconnect the PSU Adaptor plug to the DC power
socket in the Control Panel and switch On the
supply to the PSU Adaptor.
9. Reset jumper link P1 into the OFF position.
10. Close the Control Panel cover and refit the fixing
screws.
PROGRAMMING
INSTRUCTIONS
With the system in Standby Mode with the Power LED
ON.
Press , ,
The Arm and Part-Arm LEDs will illuminate and all
Zone, Fire and tamper LEDs will flash.
The system is now in the Programming Mode
Note: After programming all required functions press
to leave Programming mode and return to
Standby.
USER ACCESS CODE
Default setting: 1 2 3 4
Press ,
Zone LEDs 1-4 will illuminate.
Enter a new 4 digit User Access code. As each digit
is entered an illuminated zone LEDs will be turned
OFF.
Press to save the new User Access code and
return to programming mode.
Press to return to programming mode without
saving.
SYSTEM HOUSE CODE
Press ,
The Zone LEDs 1-6, Fire and Tamper LEDs will
illuminate to display the current House Code setting
with an illuminated LED indicating a setting of "1" in the
House Code, LEDs which are OFF indicate a "0".
For example:
A house code of 11110010, will be indicated with zone
LEDs 1-4 ON and 5-6 OFF, Fire LED ON and Tamper
LED OFF.
a) At the Control Panel:
By pressing buttons 1-8 on the Control Panel,
configure the status LEDs so that they indicate
the required house code setting. The LEDs will
switch to the opposite state each time the
button is pressed.
LED ON = 1, (House Code DIP Switch On/Up)
LED OFF = 0, (House Code DIP Switch Off/Down)
Press to save the new setting and return to
programming mode.
Press
to return to programming mode without
saving.
b) Using a Remote Control:
With the required House Code already configured,
press the DISARM button on the Remote Control.
The Control Panel will beep twice to acknowledge
the signal.
The Zone, Fire and Tamper LED status will be
updated to correspond with the House Code set
on the Remote Control and now programmed into
the Control Panel.
Press to return to programming mode.
20
1
ENTER
ENTER
ENTER
ESC
ESC
2
ESC
OFF
ON
Jumper
Link P1
User Access Code
?
?
?
?
ENTER
