6
The Remote Control Unit(s) are used to Arm, Part-Arm
and Disarm the system.
The Remote Control Unit also incorporates a Personal
Attack (PA) switch. Activating the PA switch on the
side of the Remote Control will immediately trigger an
alarm (unless the Control Panel is in Test or Program
Modes) even if the system is disarmed. The alarm can
be cancelled by pressing the ’DISARM’ button on the
Remote Control or via the Control Panel.
Any number of Remote Control Units can be used with
your system, providing they are all coded with the
system House Code (DIP switch settings).
The Remote Control is powered by a CR2032 type
Lithium cell which under normal conditions will have an
expected life in excess of 1 year. Under normal battery
conditions the LED on the Remote Control will only
illuminate when a button is pressed. However, under
low-battery conditions this LED will continue to flash
after the button has been released. When this occurs
the battery should be replaced as soon as possible.
CONFIGURING THE REMOTE
CONTROL
1. Remove the rear cover by undoing the small screw
on the rear of the Remote Control and keeping it
safe for later.
2. Select and record (in the Alarm Record section of
this manual) a random combination of ‘ON’ and
‘OFF’ positions for the DIP switches. This will
become the system House Code that enables all
devices to communicate with the Control Panel.
IMPORTANT:
The House Code for your system
should be changed from the factory default setting.
3. Ensure that the Jumper Link located immediately
below the House Code DIP switches is fitted in
position for use with this alarm system.
4. Insert the battery under the clip ensuring that the
+
terminal faces upwards away from the Circuit
Board.
5. Replace the rear cover and fixing screw. Do not over
tighten the screw as this could damage the thread.
Testing the Remote Control:
6. Press the button. The Transmit LED should
illuminate while the button is pressed and
extinguish within 1 second of releasing the button.
7. Press the and buttons in turn to
ensure that the Transmit LED illuminates as before.
REMOTE CONTROL UNIT
Slide up
to operate
Transmit LED
Personal Attack
Arm
Part-Arm
Disarm
House Code
DIP Switches
Jumper
Link
Battery Clip
Battery
