INSTALLING AND CONFIGURING THE
SOLAR SIREN
1. Remove the fixing screw from the bottom edge of
the Siren housing and carefully hinge off the front
cover. All electronic components are housed within
the front cover.
2. Hold the mounting plate in position and mark the
positions of the four mounting holes. A spirit level
placed on the casing will ensure a perfect level.
Drill four 6mm holes and fit the wall plugs.
3. Fit the two 30mm fixing screws in the top holes
leaving approximately 10mm of the screw protruding.
4. Fit the top keyhole slots of the mounting plate over
the screw heads. Remove the mounting plate and
adjust the screws until they form a neat fit with the
mounting plate with minimal movement.
5. Secure the mounting plate in position using the
two 25mm fixing screws in the bottom fixing holes.
6. Ensure that the Solar Siren main configuration
switch on the LED strobe board is set to "SIREN"
for use with this alarm system.
7. Undo the 3 screws holding the DIP Switch Cover
in place and remove the cover.
8. Under the cover you will find a series of 9 DIP
switches.
Note: When the Solar Siren is viewed as shown
above (Solar panel at top) the DIP switches are
‘upside down’.
9. DIP switches 1-8 are used to set the House Code
for the Siren and must be set to the same ON/OFF
combination as all other system devices.
10. If required the maximum length of time that the
External Solar Siren will sound for when activated
under an alarm condition may be limited to 3
minutes using DIP switch 9 as follows:
OFF
3 minutes
ON
as Control Panel setting
16
Tamper
switch
6 Volt 1.2Ahr
rechargeable
battery
9 Volt PP3 initial
power up battery
Siren
Printed circuit
board enclosure
Receiver
Aerial
DIP switch
cover
Alarm duration
DIP switch 9
House Code
DIP switches 1-8
7.5 Volt DC
charging adaptor
input
Front cover
locating tabs
Beep Disable Link
Siren Disable Link
Strobe PCB
Solar Panel
C.U.
Main Configuration Switch
(in SIREN Position)
SIREN
C.U.
SIREN
Inside View of Siren
Alarm Duration DIP switch 9
(Always change from the factory setting)
House Code
Main Configuration Switch
(in SIREN Position)
C.U.
SIREN
