Ford Granada 1985-1994, Руководство пользователя

Страница: 212 / 254

1 Remove the overhead console.
2 Remove the three bolts which secure the
motor (see illustration). Lower the motor,
disconnect the multi-plug and remove it.
Recover the relay.
3 When refitting, make sure that the motor
drivegear meshes with the roof operating
mechanism. Refit the relay, reconnect the
multi-plug and secure the motor with the three
bolts.
4 Check the operation of the motor, then refit
the overhead console.
1 All vehicles are fitted with an electrical
speedometer sender unit instead of a
mechanical cable. The sender unit is located on
the left-hand side of the transmission extension.
2 Raise and securely support the front of the
vehicle. Place a drain pan underneath the
speedometer sender unit.
3 Remove the securing bolt, pull the sender
unit out of the transmission and disconnect
the multi-plug (see illustration). Be prepared
for some spillage of gearbox oil or ATF
(automatic transmission fluid).
4 If a new sender unit is being fitted, transfer
the driven gear and circlip from the old unit.
On automatic transmission models, also
transfer the O-ring.
5 If the old sender unit had two connecting
wires and the new unit has three, the brown
wire must be cut at the multi-plug and an earth
tag fitted (see illustration). Consult a Ford
dealer if in doubt.
6 Fit the new sender unit, using a new bolt
(M6 x 25 mm for manual gearbox, M6 x 35 mm
for automatic transmission). Besides the
sender unit, the bolt also secures the new
earth tag (when applicable), the radio earth
strap and the multi-plug retaining bracket.
7 Connect the multi-plug and fit it to the
bracket.
8 If any spillage of gearbox oil or transmission
fluid occurred, top-up the level before the
vehicle is next run.
All models
1 To remove a windscreen wiper arm, first
open the bonnet.
2 Lift up the plastic cap and undo the wiper
arm retaining nut.
3 Pull the arm off the drive spindle (see
illustrations).
4 Refit in the reverse order to removal, using
the masking tape to indicate the correct fitted
position of the arm and blade.
5 To remove a blade alone, hinge the arm and
blade away from the screen. Press the tab on
the spring clip in the middle of the blade and
unhook the blade from the arm (see
illustration).
6 Refit the blade by sliding it onto the hook on
the arm.
22 Wiper arms and blades -
removal and refitting
21 Speedometer sender unit -
removal and refitting
20 Sliding roof motor - removal
and refitting
13•16 Body electrical system
20.2 Sliding roof motor retaining bolts
(arrowed)
22.3b Pull the arm off the spindle
22.3a Lift the cap to expose the nut
22.5 Removing a wiper blade 22.7 Disconnecting the rear wiper arm
washer hose
21.3 Speedometer sender unit securing
bolt (arrowed)
A Automatic transmission
B Manual gearbox
21.5 Latest type speedometer sender unit
A Brown wire
B Brown/yellow wire
C Brown/black wire
D Earth tag (see text) E Sleeve
F Cut brown wire
here (see text)
Mark the position of the blade
on the windscreen or rear
window (as applicable) with a
piece of masking tape.