Ford Granada 1985-1994, Руководство пользователя

Страница: 185 / 254

5 Free the glass from the channels. Carefully
remove the glass upwards through the
window aperture.
6 Refit by reversing the removal operations.
Note that the channels are adjustable: wind
the window up and down after securing the
channels and adjust them if necessary for
smooth operation. The regulator mechanism
can also be adjusted (see illustration).
Rear door
7 Remove the two screws which secure the
window channel (see illustration).
8 Remove the two screws which secure the
glass to the regulator mechanism. Free the
glass from the channel and carefully lift it out
through the window aperture.
9 When refitting, secure the glass and the
channel, then make sure that the window can
wind up and down smoothly before
proceeding further. Adjust the channel or
regulator if necessary.
10 Refit the weatherstrip and trim panel.
1 The window regulator mechanism is riveted
to the door skin. A blind rivet gun will therefore
be needed for successful refitting.
2 Remove the door interior trim panel and
peel back the foam rubber sheet.
3 Support the glass and remove the two
screws which secure it to the regulator
mechanism. Wedge or tape the glass in the
raised position.
4 When applicable, disconnect the window
motor multi-plug (see illustration).
5 Remove the two slide screws and drill out
the four rivets which secure the regulator (see
illustrations). Remove the regulator through
the large lower aperture in the door.
6 When refitting, secure the regulator with the
two slide screws, then fit four new rivets in the
rivet holes.
7 The remainder of refitting is a reversal of
removal.
The windscreen, the rear (tailgate) window
and the rear quarter windows are all secured
and weatherproofed by special adhesives. The
equipment and skills required to remove and
refit this type of window are beyond the scope
of this book. Consult a Ford dealer or a
windscreen specialist.
1 Open and prop the bonnet.
2 When an under-bonnet light is fitted,
disconnect its wire. Remove the screw which
secures the light, pull the wire through the
insulation panel and remove it.
3 Remove the centre screws from the plastic
fittings which secure the insulation. Prise the
outer parts of the fittings out of the bonnet and
remove the insulation panel.
4 Refit by reversing the removal operations.
Feed the under-bonnet light wire into place
before finally securing the insulation panel.
Early models
1 Open and prop the bonnet.
2 Remove the two screws which secure the
centre section of the grille.
3 When fitted, remove the headlight washer
jets by pulling them out of their fittings.
4 Release one end of the grille side section
from its fixing next to the direction indicator
lens (see illustration). Carefully pull the side
section away from its mountings until it can be
separated from the grille centre section.
5 The centre section can now be released
from the other side section by raising the tang
on the catch which holds the sections
together, then twisting them apart (see
illustration).
6 Refit by reversing the removal operations.
27 Radiator grille - removal and
refitting
26 Bonnet insulation panel -
removal and refitting
25 Windscreen and fixed glass -
removal and refitting
24 Door window regulator
mechanism - removal and
refitting
Bodywork and fittings 12•9
12
23.6 Window regulator adjustment screws
(C)
A Front door B Rear door
23.7 Rear door window channel screws (A)
24.5a The two regulator slide screws
(arrowed)
24.4 Window motor multi-plug
24.5b Two of the rivets (arrowed) which
secure the regulator
Two other rivets are out of shot to right
27.4 Removing a grille side section