Fondital Antea 24kW Range, Руководство по установке, использованию и обслуживанию

Страница: 10 / 60

10
2.2. LCD
a. flue cleaning function indicator (function reserved for installation/service technician)
This indicator flashes when the flue cleaning function is active (press the “info” and “reset” buttons simultaneously). The boiler flow water
temperature and the fan speed (rpm) are shown (in this case, symbol f is also shown)
b. DHW indicator
This comes on when the boiler is in DHW mode.
Flashes when adjusting the DHW temperature with the buttons 1 (fig. 1).
c. Parameter editing indicator
This comes on when the value of the parameter can be modified (in this case, the indicator lights together with the symbol m). When edited
parameter value is confirmed this symbol will flash.
d. Alphanumeric indicator
This shows the following:
- CH flow water temperature
- CH temperature setting
- DHW temperature setting
- boiler status
- boiler diagnostics
e. Central heating indicator
This comes on when the boiler is in CH mode.
It flashes when adjusting the central heating water temperature with the buttons 6 (fig. 1).
f. fan speed in rpm (function reserved for installation/service technician)
When the flue cleaning function is activated, symbol a turns on and flow water temperature and
fan rpm are shown (in this case, this symbol is also shown).
g. Calculated room temperature indicator
When an external probe is installed, this indicator flashes when the calculated room temperature is set via buttons 6.
h. Boiler status indicator
The two icons indicate the currently active operating modes:
SUMMER: only icon lits.
WINTER: both icons lit.
CENTRAL HEATING ONLY: only icon lits.
STANDBY: symbol displayed in alphanumeric indicator d
i. flame indicator
This comes on when the burner flame is present.
l. Parameter indicator
Figures to view and edit parameters and indicate the burner current power rate (percentage).
m. Parameter indicator
It turns on when entering the parameter programming mode.
fig. 2
a
b
d
f
g
h
l
i
c e
m
8. Time clock
The time clock is for central heating control only. The clock is provided with a selector switch with three positions:
a) Position “I”
CONSTANT: in this position, the clock circuit is always closed (switch on), therefore the boiler will constantly on and
will only shut off upon the request of the room thermostat (if installed) or the heating thermostat;
b) Position “O” HEATING OFF: in this position, the clock circuit is always open (switch off) and the boiler will therefore never
fire for heating, Domestic hot water will operate on demand;
c) “Central” position PROGRAMMING ACTIVE: in this position, the programming set by the user is active.
Using the three position switch the timer will allow constant operation, timed operation or central heating off. Move the switch lever by
sliding to the desired position.
The time clock is provided with 72 switches, each of which cover a time interval of 20 minutes (three per
hour).
When a tappet is switched from the outside (on setting) to the inside of the clock border (off setting), the
circuit is open (switch off) for a period of 20 minutes and then the boiler stops.
To set the time of da set the time of day, turn the timer outer bezel clockwise, to align the pointer with the
correct time to the nearest 20 minutes. Do not at any time attempt to turn the bezel anti-clockwise.
For set the timed heating program, decide which times of the day the central heating is required. The heating
will operate when the green tappets are set to the outer edge of the bezel.
To ensure the heating stays OFF set the required tappets inwards towards the centre of the bezel.
ON
OFF
Tapped position