Fluke 5522A Operators, Руководство оператора

Страница: 228 / 426

5522A
Operators Manual
6-40
SRQSTR?
Sequential Overlapped Coupled IEEE-488 RS-232
x x x
x
x
(Service Request String query) Returns the string programmed for Serial Mode SRQ
response. This is the format of the Service Request String; actual values come from the
registers. Also see the
SPLSTR
command.
Response: <string>
Example:
SRQSTR
returns
SRQ: %02x %02x %04x %04x\n
Returns the
SRQSTR
string format (default settings in this example).
*STB?
Sequential Overlapped
Coupled
IEEE-488 RS-232
x x x x x
(Status Byte Register query) Returns the byte for the Status Byte Register. (See “Status
Byte Register (STB)” in Chapter 5.)
Response: <value> (the decimal equivalent of the STB byte, 0 to 255)
Example:
*STB?
returns
72
Returns
72
if bits 3 (EAV) and 6 (MSS) are set.
STBY
Overlapped Coupled IEEE-488 RS-232 Sequential
x x x x x
(Standby command) Deactivates the Calibrator output if it is in operate. This is the same
as pressing the Calibrator front panel
Y
key.
Parameter: (None)
Example:
STBY
Disconnect the selected output from the Calibrator front panel terminals.
SYNCOUT
Overlapped Coupled IEEE-488 RS-232 Sequential
x x x x x
(Synchronization Pulse command) Sends a synchronization pulse out to a slave
Calibrator through the 10 MHZ OUT BNC connector.
Parameter: (None)
Example:
SYNCOUT
TC_MEAS
Sequential Overlapped Coupled IEEE-488 RS-232
x x x x
x
(Thermocouple Measure command) Selects the measure thermocouple mode.
Parameters:
CEL
(Celsius) (optional)
FAR
(Fahrenheit) (optional)
Example:
TC_MEAS CEL
Measure the thermocouple temperature that is attached to the Calibrator TC terminals, in
Celsius.
TC_OFFSET
Overlapped Coupled IEEE-488 RS-232 Sequential
x x x x x
(Thermocouple Temperature Measurement Offset command) Adds a temperature offset
to thermocouple measurements (±500
°
C). This command does not apply to
thermocouple sourcing.
Parameters: <value>
CEL
(offset in Celsius) (optional)
<value>
FAR
(offset in Fahrenheit) (optional)
Example:
TC_10 CEL