Flowserve IJ, Установка, эксплуатация и обслуживание

Страница: 39 / 128

IJ PUMP OPERATION AND MAINTENANCE MANUAL
BO2660-01 3-4
4. precision machinist level or equivalent tool;
5. optical alignment equipment such as an alignment laser or jig transit that is capable of
measuring to 0.001 in (0.02 mm);
6. dial indicator;
7. indicator bracket.
3.2.2 ONE BASEPLATE FOR ENTIRE TRAIN OF UNITS
Where your baseplate is designed with two or more sets of mounting pads which accommodate the
entire train of units (for example, pump, driver, and fluid drive) the manufacturing process for the
baseplate assures alignment of every set of mounting pads; thus, you need only level such a baseplate
on its foundation as directed by the procedure below, anchor it down, and you are ready to grout.
Before beginning the leveling work as outlined below, you must remove all units, except the pump,
from their mounting pads. These pads must be vacant while both leveling and grouting the baseplate.
Among the illustrations that highlight the instructions, there is the BASEPLATE TOP VIEW figure,
which shows the pump mounted and two sets of mounting pads A-B and C-D vacant; a typical
example of a baseplate that is ready for leveling. Of course, your baseplate (see OUTLINE drawing)
could include an additional set of pads or where only the driver and pump make up the entire train,
your baseplate would be less the innermost set of pads, which are labeled C-D in the BASEPLATE
TOP VIEW figure. Regardless of how many sets of mounting pads your baseplate may have, the
leveling procedure is essentially the same. Proceed as follows:
Figure 3-3 Baseplate Top View (Typical)
1. Verify that your foundation as described under PREINSTALLATION, has had ample curing
time; otherwise it may not support weight of pump train.
2. To assure sufficient grouting, provide for a minimum space of 1 in (25 mm) between
baseplate and foundation by placing shim blocks adjacent to each foundation bolt hole or
underneath each leveling screw in the baseplate.