Flowserve IJ, Установка, эксплуатация и обслуживание

Страница: 123 / 128

IJ PUMP OPERATION AND MAINTENANCE MANUAL
BO2660-01 6-40
Some straight half-couplings are secured in position with
shaft nuts as well as keys.
3. installing key on driver or pump shaft and sliding cold sleeve and O-ring followed by heated
hub (or heated solid half-coupling, if so equipped) onto shaft until half-coupling is positioned
as shown by the OUTLINE drawing in the back of this manual;
CAUTION
Lubrication of the coupling (see APPENDIX for
manufacturer's instructions) must be accomplished before
operation of the pump for the first time.
4. verifying that gear type couplings are lubricated;
CAUTION
Use of odd size bolts and nuts to couple half-couplings and
spacer will cause imbalance; use only bolts and nuts
specified by the coupling manufacturer.
5. bolting half-couplings and coupling spacer together after all requirements under COUPLING
PUMP AND DRIVER have been met.
6.6.8 FINAL ASSEMBLY TASKS
If you have not already done so:
1. Remove thrust bearing housing end cover (61). Apply an even film of sealant to parting
surface of end cover that abuts bearing housing. Install cover with stationary oil baffle or
Inproseal stator (if installed), and evenly tighten capscrews.
2. Wipe off any excess sealant.
3. Reinstall all piping, wiring, auxiliary components, or other items removed to allow pump
disassembly.
4. If case or driver position has not been disturbed, perform hot alignment check of pump and
driver in accordance with paragraph 3.4.9. Otherwise, perform cold alignment check as
outlined in paragraph 3.4.8.