Festo Checkbox Compact CHB-C-X, Руководство пользователя

Страница: 118 / 148

A. Technical appendix
A−6
Festo P.BE−CB−COMP−en en 0503c
Code Remedy Cause
F 05 Only CHB−C−P/..X:
Material jam (warning)
Signal on plug PLC A/23 = HIGH
The Checkbox has not received
any conveyed parts for at least
30 seconds
1)
.
1)
Duration variable, can be set with
CheckKon
With manual supply: Quit faults, supply further test
parts or stop the Checkbox.
With automatic supply: Fill up small parts conveyor,
check supply path for material jam, quit warning.
E 06 Maximum permitted parts
length exceeded
Fault E 06 is shown only if the
CheckKon function Forced
abort of analysis" is switched
on. With CheckKon: Set the parameter Max. parts length"
correctly.
Set the conveyor device so that the parts follow each
other at a recognizable distance.
E 07 Optical fault:
Reduced brightness Clean the glass surfaces on the prism.
E 08 Only for operation with
encoder:
Conveyor device blocked or
encoder does not turn. Checkbox has no control over the conveyor device.
Check the fitting and installation of the encoder.
E 09
E 10 Overload of internal I/O module 1. Stop the Checkbox.
2. Check whether external outputs are loaded with an
excessive current.
3. Start the Checkbox.
or contact the Festo after−sales service.
E 12 Over temperature Check ambient temperature.
Prevent warmth from outside e.g. by sun shine.
E 14 Only for operation with en
coder:
Conveyor speed for the set
ratio encoder frequency/
linefrequency of the camera
(F
EZ
−value) too high.
Reduce conveyor speed.
With CheckKon: Adapt F
EZ
−value.
E 19 Incorrect operating system The operating system must match the type of CHB−C−...
Install the correct operating system variant ...−C, ...−P
or...−X.