Festo Checkbox Compact CHB-C-X, Руководство пользователя

Страница: 102 / 148

6. Testing parts
6−4
Festo P.BE−CB−COMP−en en 0503c
6.2 Test mode
Stop The Teach procedure is concluded and the Checkbox is
ready to operate (Stop status).
CHB−C−P/..X
Set the desired parts type via the PLC interface
(chapter4.3.3).
1. Provide test parts for each parts type:
·
Use good, bad and incorrectly−orientated parts from
the parts assortment.
·
Test a sufficient number of parts in order to obtain a
reproducible result.
Show e.g. 6 good parts per orientation as well as
6bad parts.
1 5 2. Press the button
START
/STOP (AUTO mode). Test parts
from the displayed parts type (e.g. 1 ) with the factory−set
tolerance of 5% .
3. You do not need to be very careful when placing the parts
on the conveyor belt.
If possible, use the conveyor device intended for the parts
test. The test parts should be positioned (at random), as
in normal operation.
E 05 If the supply of parts is interrupted for a long period, the
Checkbox will show fault message E05 or warning F05 and
will stop automatically (see chapter 2.7 and appendix A.1.2).
4. Check the test results e.g. with regard to the following
aspects: Have the orientations been recognized correctly?
Is the separation of the recognized parts into good/bad
correct?