Feig Electronic ID ISC.MR102, Руководство пользователя, Страница: 29 / 153

Identification Manual ID ISC.MR102
FEIG ELECTRONIC GmbH Page 29 of 153 H01113-4e-ID-B.docx
4.3. CFG2: Inputs / Outputs general
Via the following parameters the operation mode of the LED can be configured at any time. One
byte each is reserved for the active and mute position, by means of which the individual operation
modes according to the schedule below may be adjusted. In addition to this, for the active- and
mute position different flashing frequencies of the LED may be defined. So, the LED may be used
as an operation indicator.
Byte 0 1 2 3 4 5 6
Contents 0x00 0x00 0x00 IDLE-STATE IDLE-FLASH 0x00 0x00
Default 0xA9 0x00
Byte 7 8 9 10 11 12 13
Contents ACTIV-
STATE ACTIV-
FLASH ACTIV-
GRN-TIME
ACTIV-
RED-TIME
0x00 0x00 0x00
Default 0x26 0x00 0x0A 0x0A
1 sec. 1 sec.
Note:

The following configuration values are not valid for the ID ISC SPAD102.

The blue LED on the ID ISC SPAD102 will be active if the HF-field is active.

The blue LED on the ID ISC SPAD102 will flash slowly if a tag has been detected.

The Readers ID ISC.MR102 dispose of a two colored LED (red / green). The color or-
ange can be obtained by combining both basic colors red and green.
Colors
LED
Color:
red green
red 1 0
green 0 1
orange 1 1