Identification
Manual
ID ISC.MR102
FEIG ELECTRONIC GmbH
Page 137 of 153
H01113-4e-ID-B.docx
**
The WR-OPTION will be set automatically by the FEIG readers if the WR-OPTION pa-
rameter in “CFG4 General” is set to “00: automatically set”
When using the “non-addressed” mode the WR-OPTION must be set manually to “WR-
OPTION = 1”.
Note:
The “Write_2_Blocks” command and “Lock_2_Blocks” command will be used automati-
cally by the reader. This will only become an effect if the block address starts with an
even-numbered address.
In the case of writing / locking an odd number of blocks the
“Write_2_Blocks”/“Lock_2_Blocks” command will be combined with the “write single
Block”/ “Lock single Block” command.
