Identification
Manual
ID ISC.MR102
FEIG ELECTRONIC GmbH
Page 115 of 153
H01113-4e-ID-B.docx
Supported ISO15693 Host commands
8.3.
Supported ISO15693 Host commands for ISO15693 Transponders
The command codes listed in the following table supports the various Transponder commands and
operations that are available for each ISO15693 Transponder type.
8.3.1. Fujitsu (MB89R116)
IC manufacturer identifier: 0x08
Chip ID: 0h = 00000000b (Bit 47 - 40 of UID)
Memory organization: 256 x 8 Byte = 16kBit
Number of blocks
256 (user area: 0
– 249)
Block size
8 byte
WR-OPTION
0 or 1
Command
Code
Function
Mode
Comment
non-
addressed
addressed
select
0x01
Inventory
-
-
0x02
Stay Quiet
-
-
0x22
Lock Multiple Blocks
0x23
Read Multiple Blocks
*
Security Status is always
0x00
0x24
Write Multiple Blocks
**
0x25
Select
-
-
0x26
Reset to Ready
0x27
Write AFI
0x28
Lock AFI
0x29
Write DSFID
0x2A
Lock DSFID
0x2B
Get System Information
0x2C
Get Multiple Block Security
Status
*
The Custom Specific Commands Read Multiple Blocks Unlimited [0xA3] will be used automatically by the
Reader. In non addressed Mode only one or two blocks can be read and the parameter DB-Blocksize in
CFG4 should be set to 8.
**
The WR-OPTION will be set automatically by the FEIG Readers if the WR-
OPTION parameter is set to “00:
a
utomatically set”. Up to two blocks of data can be written for one request.
8.3.2. Fujitsu (MB89R118)
