FDI P2131, Техническое руководство, Страница: 75 / 161

Section 3.7 Checklist for Transport and/or Storage
CHECK OPERATION
1. Ensure that the water in the WRS is at the HIGH mark (add some
water if needed using the SWS).
2. Remove the top panel from the WRS.
3. Pour in 1/2 gallon of household chlorine bleach (3 ‐ 6% sodium
hypochlorite) to the bleach port of the WRS water tank. Reference
Section 4.5.
CAUTION : Do not pump water into the SMU until bleach has been
rinsed from the WRS.
4. Run a Textile 4/5 cycle. The 4/5 cycle has a total cycle time of over
20 minutes, providing continuous water circulation in the WRS to
ensure complete contact and effective disinfection. Drain the WRS
and refill with deionized water from the SWS. Run a Textile 4/5
cycle. This will help rinse any remaining bleach solution.
5. Perform the Jacket Blowdown Procedure in Section 4.1 to remove
any contaminants that may have accumulated in the jacket. Allow
the SMU to cool to ambient temperature. Remove the drain hose.
WARNING : Do not blow out with compressed air.
6. Confirm the SMU power switch and the WRS power switch are in
the OFF position.
7. Disconnect the WRS power cord and store in SMU endcap.
8. Disconnect the SMU power cord and store in endcap.
9. Ensure the jacket and chamber are at 0 psig. The jacket and
chamber vent valves should be left open for storage.
10. Remove the shelves and place in the SAB for transport.
11. Remove the chamber drain screen and clean. Place the drain screen
in the SAB for transport for S/N’s AFS ‐ 0001 through AFS ‐ 0203. On
S/N’s after AFS ‐ 0204, the drain screen can be left in chamber.
12. Remove the three hoses between WRS and SMU and install the
caps. Store hoses inside the SAB.
13. Remove shims from under SMU and store inside the side pocket of
the SAB.
Continued on next page
69