FDI P2131, Техническое руководство, Страница: 32 / 161

39. Ensure the jacket vent valve on the back of the SMU is fully open and close the chamber
vent valve. This will allow the jacket to vent the air while it is filled with water from the
WRS. Minimizing air in the jacket improves sterilizer performance since air acts as an
insulator during sterilization.
40. Press and hold the “Water to Sterilizer” button on the WRS and fill the SMU to the HIGH
mark on the level sight glass. This should pump about 4.25 gallons of water into the jacket
of the sterilizer. Add water to the WRS with the SWS as needed to fill the SMU to the HIGH
mark.
CAUTION : Verify the SMU sight glass fills from the bottom. If not, contact a qualified
maintenance technician to inspect the sight glass plumbing for debris.
CAUTION : Never add water to the jacket during a cycle. This will cause the jacket to cool,
lose pressure, and alarm.
41. Firmly close the jacket vent valve on the back of the SMU.
42. Refill the WRS back to its HIGH mark and disconnect the SWS hose.
43. Reset the “02 – LOW WATER LEVEL” alarm. If the alarm clears, the liquid level switch is
functioning correctly in the “Water OK” position.
CAUTION : If this “Low Water” alarm does not reset, contact a qualified maintenance
technician to inspect the liquid level switch and liquid level switch plumbing.
44. On the "CONFIRM SETUP” screen, make any necessary updates to the TIME, DATE, or
UNIT ID. To do so, touch the box to the right of the metric that needs to be updated. A
new screen will appear for the user to make any desired updates. This screen will appear
every time the Control Power is turned ON.
NOTE : The correct water levels are HIGH/HIGH ‐ when the water is at the HIGH mark
in the jacket, the water level should be at or near the HIGH mark in the WRS.
26