Fast BW750, Руководство по эксплуатации

Страница: 54 / 84

54
2. Open the water supply valve to fill the hose.
IMPORTANT: The water source MUST be higher than the
sprayer pump. NEVER run the sprayer pump dry. The
sprayer pump will not draw water from a source lower than
the pump, until the pump is primed.
If Equipped With Manual Control Rinse System:
• Turn the manual three way ball valve identified as “Valve
E” (located under the platform on left side of sprayer) to
the “OFF” position (handle pointed down).
If Equipped With Electric Control Rinse System:
• Located under the operator platform on the left side of
the sprayer is an electric three way ball valve. Directly
behind this valve is a manual ON/OFF valve with a
yellow handle. Turn this valve OFF (handle should point
toward rear of sprayer). When handle is pointed toward
right side of sprayer the valve is ON.
3. Open the “Fast Fill” valve marked as “Valve F.”
4. Start the product pump and run at full capacity.
5. Slowly open the “Product Tank Fill” valve marked “Valve
C” located on the front control stand. Let run until the
product tank is full, then turn OFF “Product Tank Fill”
valve. There is a breather on the product tank lid to
allow air to escape during filling.
6. Stop the product pump.
7. Close the “Fast Fill” valve.
If Equipped With Manual Control Rinse System:
• Turn the manual three way ball valve identified as “Valve
E” (located under the platform on left side of sprayer) to
the “Product Tank” position (handle pointed toward rear
of sprayer).
If Equipped With Electric Control Rinse System:
• Located under the operator platform on the left side of
the sprayer is an electric three way ball valve. Directly
behind this valve is a manual ON/OFF valve with a
yellow handle. Turn this valve ON (handle should point
toward right side of sprayer). When handle is pointed
toward rear of sprayer the valve is OFF.
8. Turn off the external water source.
9. Remove the fill hose and replace the dust cap. Be
careful when removing the fill hose from the connector,
there could still be some liquid in the line.
1 - Valve C
1 - Yellow Handle
9.17 Priming The Sprayer
NOTE: Before you prime the sprayer, make sure you are
familiar with the information in the pump owner’s manual.
1. Determine appropriate operating pressure for the
sprayer system.
2. Fill the sprayer tank half full of water. DO NOT add
chemicals.
IMPORTANT: Water must be in pump before pump is started.
Pump may be damaged if pump and suction lines are empty.
Use the transfer pump or fill through top port.
3. Open the emergency shut-off valve to allow water to
flow from the tank into the suction line and pump.