Fast BW750, Руководство по эксплуатации

Страница: 58 / 84

58
9.20 Chemical Inductor (Optional)
The 5 gallon Chemical Inductor is an optional accessory and
is mounted on the front left corner of the spray platform. The
chemical inductor is used to add chemical to the product
tank from ground level.
^
DANGER
Handle ALL agricultural chemicals with care.
Use chemicals ONLY as directed on the
manufacturer’s warning label.
Wear protective clothing (such as goggles,
rubber or chemical resistant gloves and a
respirator) while handling chemicals. Keep
protective clothing clean and in good condition
or discard.
Wash hands and face thoroughly with clean
water after handling chemicals.
Never eat, smoke, drink or put hands to mouth
before washing.
Follow these procedures to properly use the chemical
induction system:
1. Sprayer product tank MUST have at least 50 gallons of
water.
2. Check that the emergency shut off valve located under
the product tank is OPEN.
3. Start the product pump and run at rated speed.
4. OPEN the Chemical Fill Control valve.
5. If you are going to use the measuring marks on the
chemical inductor tank to measure the amount of
chemical being added, make sure the valve on the
bottom of the chemical inductor tank is CLOSED. Add
desired amount of chemical, then OPEN the valve at
the bottom of the chemical inductor tank. The chemical
will be transferred from the chemical inductor tank to the
product tank.
NOTE: Poly tanks can vary in size and expand and contract
from hot to cold weather. It is not recommended to use the
measuring marks on the chemical inductor tank for precise
measuring.
If you do not need to use the chemical inductor tank to
measure, you can OPEN the valve at the bottom of the
chemical inductor tank prior to adding the chemical. The
chemical inductor will transfer the chemical to the product
tank as you are filling.
1 - Chemical Inductor Tank Cover
2 - Chemical Inductor Tank
3 - Close This Valve To Measure Chemical
4 - Chemical Fill Control Valve
6. When transfer is complete, use the hand rinse gun to
rinse the chemical inductor tank. Allow the rinse water
to go through the chemical inductor into the product
tank.
NOTE:
• If the hand rinse gun is supplied with water from the
product pump, the water will come from the product
tank and will be contaminated with diluted chemical.
• If the hand rinse gun is supplied with water from the
optional 12 volt electric pump, the water will come from
the rinse tank.
7. Always turn the valve under the chemical inductor tank
OFF before turning the “Chemical Fill” valve OFF.
8. Replace the chemical inductor tank lid.
9. Fully OPEN the “Agitation” valve and allow the product
pump to run long enough to thoroughly mix the product
tanks contents.
1 - Hand Rinse Gun