Fast BW750, Руководство по эксплуатации

Страница: 27 / 84

27
5.2 Hydraulic Drive Sprayer Pump Hose
Hook Up (Optional)
Hydraulic Hose Hook Up:
^
WARNING
Hydraulic oil under pressure can spray into
eyes and cause physical injury. Follow tractor
operator manual instructions for shutting
off hydraulic supply and relieving hydraulic
pressure before connecting or disconnecting
hydraulic hoses.
1.
Assemble the sprayer hydraulic pump hoses to the
tractor hydraulic couplers.
IMPORTANT: Assemble the hoses to the tractor, but DO
NOT activate hydraulics until the pump has been properly
primed.
2.
Place the tractor hydraulic control lever in the position
next to the float position. The pump should operate. If
the pump does not operate, place the tractor hydraulic
control lever in the float position.
3.
Disconnect and reverse the sprayer hose connections
at the tractor. The pump should operate.
IMPORTANT: Always use the float position to STOP the
hydraulic sprayer pump.
Note: If sprayer is being hitched to the tractor for the first
time, charge the sprayer hydraulic system with oil.
IMPORTANT: The storage slots for the hydraulic hoses
should ONLY be used when sprayer is disconnected from
the tractor and being stored. Hydraulic hoses MUST always
be connected to tractor during transport of sprayer.
5.3 Control Box Installation
5.3.1 Electrical Connections To Tractor
When connecting the electrical control boxes to the tractor, it
is recommended that you purchase a wiring harness pigtail
adaptor from your tractor dealer or Fast Manufacturing, Inc.
Be sure to ONLY connect to tractors with a 12 Volt Positive
electrical system.
5.4 Electric Sprayer Controls
Note: Refer to the separate control box owner’s manual for
detailed installation instructions.
1. Turn OFF all switches.
2. Install control box in the tractor cab in a location where
it can be used easily and is readily visible.
3. Determine best routing for control cable and pressure
tube. Be sure the cables and/or tubes DO NOT interfere
with any moving parts on tractor or sprayer.
4. Install Mounting bracket.
5. Make tractor connections for power input, ground and
pressure tubing if so equipped.
TeeJet Controller (Standard):
a. Connect the 2 RED wires to the 12 volt power
source (positive).
b. Connect the 2 BLACK wires to a ground point on
the tractor (negative).
c. Connect the single BLUE wire to the tractor
headlight system. The BLUE wire powers the light
in the pressure gauge and does not turn OFF with
the control box switch. DO NOT connect directly to
a power source that does not disconnect when the
tractor is shut OFF.
d. Using the pressure tube coupler and fittings, connect
the tube in the control wiring harness to the tube
in the extension wiring harness. Install the coupler
outside the tractor cab in case it would leak.
A gauge isolator (Part No. 07.17961) is available
to use in place of the pressure tube coupler. If
it is installed outside the tractor cab, it prevents
chemicals from entering the tractor cab. It also
protects the control box gauge when liquid nitrogen
is sprayed.