Fast BW750, Руководство по эксплуатации

Страница: 73 / 84

73
Boom Level
If the boom does not hang level, secure the boom with an
overhead hoist or other suitable means. Loosen the six nuts
on the bolts which hold the boom to the tower slides. These
bolts fit through slotted holes. Level the boom and retighten
the nuts.
Boom Wing Alignment
Align boom inner and outer wings with the parallel connecting
link. Remove the pin from the clevis on the end of the link.
Turn the clevis in or out on the threaded shaft until the link is
properly aligned. Reinstall the pin.
1 - Tower Slides
2 - Boom Level Adjustment Bolts (Three Per Slide)
3 - Extension Springs
4 - Spring Anchor
5 - Adjustment Nuts
10.4.2 EF & EFT Boom Only
Boom Level
If the entire boom is not level side to side adjust the threaded
rod and spring assembly at the rear of the center boom.
Tighten the locknuts after adjustment is complete.
1 - Threaded Rod and Spring Assembly
Boom Wing Assembly Alignment
If the wing assemblies are not aligned (up or down), the wing
assemblies can be raised or lowered. Secure the boom wing
assembly with an overhead hoist or other suitable means.
Loosen the four nuts at the pivot between the center boom
and the primary boom wing. Use the overhead hoist to level
the boom wing assembly. Tighten the four nuts securely.
1 - Boom Wing Level Adjustment Nuts
Boom Wing Fold Out Adjustment
If the secondary boom wings do not unfold properly, with the
boom in the folded position, adjust the turnbuckle at the rear
of the primary boom wing until the cable is tight. Recheck
the boom breakaway tension and adjust if necessary.