15
6. Be sure sprayer is properly connected to towing vehicle
and a retainer is used through drawbar pin. Always
attach a safety chain between frame and towing vehicle.
7. Keep right and yield right-of-way to allow faster traffic to
pass. Drive on road shoulder, if permitted by law.
8. Do not exceed 20 mph (32 km/h). Reduce speed on
rough roads and surfaces.
9. Always use hazard warning flashers on tractor when
transporting unless prohibited by law.
10. Stay away from overhead power lines during transport.
Electrocution can occur without direct contact.
2.9 Storage Safety
^
1. Store unit in an area away from human activity.
2. Do not permit children to play on or around the stored
sprayer.
2.10 Tire Safety
^
1.
Failure to follow proper procedures when mounting a
tire on a wheel or rim can produce an explosion which
may result in serious injury or death.
2. Do not attempt to mount a tire unless you have the
proper equipment and experience to do the job.
3. Have a qualified tire dealer or repair service perform
required tire maintenance.
2.11 Safety Signs
^
1.
Keep safety signs clean and legible at all times.
2. Replace safety signs that are missing or have become
illegible.
3. Replaced parts that displayed a safety sign should also
display the current sign.
4.
Safety signs are available from your Distributor or the
factory.
How to Install Safety Signs:
•
Be sure that the installation area is clean and dry.
• Be sure temperature is above 50°F (10°C).
• Decide on exact position before you remove backing
paper.
• Remove the smallest portion of the split backing paper.
• Align the sign over the specified area and carefully
press the small portion with the exposed sticky backing
in place.
• Slowly peel back the remaining paper and carefully
smooth the remaining portion of the sign in place.
• Small air pockets can be pierced with a pin and
smoothed out using the piece of sign backing paper.
Содержание BW750
